The LED Life-time is defined as the estimated time to 50% degradation of initial brightness at Ta=25°C and IF =40mA. The LED lifetime could be decreased if operating IF is larger than 40mA, and increased if IF is less than 40mA. MOP-TFT480272-43A-BLM-TPR...
Instruments or compatible. For contrast ratio, Surface Luminance, Luminance uniformity and CIE, the testing data is based on TOPCON’s BM-7 or BM-5 photo detector or compatible. *Note 7: For TFT module, Gray scale reverse occurs in the direction of panel viewing angle. MOP-TFT480272-43A-BLM-TPR...
Display on/off HSYNC Horizontal sync input. VSYNC Vertical sync input Data enable Clock pin of serial interface Data input pin in serial mode Touch panel X right Touch panel Y down Touch panel X left Touch panel Y up MOP-TFT480272-43A-BLM-TPR...
10% to 90% Tsst μs CL=60pF, RL=2Kohm Gate output setting time Tgst 10% to 90% CL=60pF, VCOM output setting time 10% to 90% Tcst μs CL=40nF, RL=50ohm Time from VSD to 1 line HV mode data input By HDL[4:0] setting MOP-TFT480272-43A-BLM-TPR...
Symbol Unit Min. Typ. Max. DCLK frequency fclk VSD period time VSD display area VSD back porch VSD front porch Tvfp HSD period time DCLK HSD display area DCLK HSD back porch Thbp DCLK HSD front porch Thfp DCLK MOP-TFT480272-43A-BLM-TPR...
10 Inspection Criterion 10.1 Description This specification is made to be used as the standard acceptance/rejection criteria for the MOP-TFT480272-43A-BLM-TPR. 10.2 Sample plan Sampling plan according to GB/T2828.1-2003/ISO 2859-1: 1999 and ANSI/ASQC Z1.4-1993, normal level 2 and based on: Major defect: AQL 0.65 Minor defect: AQL 1.5...
1. If the fold mark and linear scar for polarizer is visible with operating condition, the defect is judged with line judge 2. If the fold mark and linear scar for polarizer is visible with non-operating condition, the defect is judged with the above judgment standard. MOP-TFT480272-43A-BLM-TPR...
If the display area is pushed hard during operation, some font may be abnormally drawn but the LCD will return to normal after it is reset. Slight dew depositing on terminals can cause an electro-chemical reaction, damaging traces and resulting in an open circuit. Usage under the maximum operating temperature, 50%Rh or less is required MOP-TFT480272-43A-BLM-TPR...
If any liquid leaked out of a damaged glass cell, and comes in contact with your hands, please wash it off well with soap and water MOP-TFT480272-43A-BLM-TPR...
Need help?
Do you have a question about the MOP-TFT480272-43A-BLM-TPR and is the answer not in the manual?
Questions and answers