Table of Contents
Advertisement
Multi-Projection Features
e
Select the Tiling setting to adjust the arrangement of the images to
create one large image.
• If you have installed the optional external camera, select Auto on the
master projector.
• If you have not installed the optional external camera or tiling the
images automatically was unsuccessful, select Manual.
• When selecting Manual, select Layout, and then select the number
of rows and columns you are setting up as the Row and Column
settings.
• After making the Layout settings, select Location Setup. Select the
position of each projected image as follows: Row Order to layout the
screens from top to bottom in sequential order starting with 1 at the
top, Column Order to layout the screens from left to right starting
with A on the left.
• Select the Layout and Location Setup settings on each projector you
are setting up.
f
Select the input signal to display an image.
g
Select Edge Blending to adjust the edges of the images.
• Set the Edge Blending setting to Blending/Black Level or Black
Level, and turn on the Line Guide and Pattern Guide settings first.
When you adjust the blending area using another device such as a
media server, select Black Level.
• Select the edge you want to blend on each projector, and set the
Blending setting to On.
• Select the Blend Start Position setting and adjust the blending start
position.
• Select the Blend Range setting and use the arrow buttons to select
the width of the blended area so that the displayed guides are at the
edges of the overlapping area between the two images.
• Select the Blend Curve setting and select a gradient for the shaded
area on the projectors.
When the edges are blended, turn off the Line Guide and Pattern
Guide settings on each projector to check the final settings.
h
Select the Black Level settings to make the difference less noticeable for
the overlapping areas.
• Select Color Adjustment first.
The adjustment areas are displayed based on the Edge Blending
setting.
• Use the arrow buttons to select the area you want to adjust and press
[Enter].
127
Advertisement
Table of Contents
