Get Started; Installing The Nanoprotect Filter; Preparing For Humidification - Philips HU5930 User Manual

3

Get started

Installing the NanoProtect
filter
The appliance comes with the
NanoProtect filter fitted inside. Remove
the packaging of the filter before using
the appliance. Remove the NanoProtect
filter, unpack it, and place it back into the
appliance described as follows:
Note
•
Make sure that the side with the tag is
pointing towards you.
•
The pre-filter is fitted inside of the back
panel.
1
Pull the top part of the back panel towards
you to release it from the appliance
(fig. c).
2
Remove the NanoProtect filter from the
appliance (fig. d).
3
Remove all packaging materials of the
NanoProtect filter (fig. e).
4
Place the NanoProtect filter back into the
appliance (fig. f).
5
To reattach the back panel, mount the
panel onto the bottom of the appliance
first, and then push the top of the panel
against the appliance (fig. g).
6 EN

Preparing for humidification

1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. i).
3
Remove all packaging material of the
NanoCloud rotary humidification wick
(fig. j).
Note
•
The humidification wick has been
assembled on the wick wheel upon
purchase.
4
Place the wick wheel on the wick support
(fig. k).
Note
•
When placing the wick wheel on the wick
support, make sure that the projections on
the wick wheel falls into the corresponding
grooves.
5
Place the water tray back into the
appliance (fig. l).
6
Turn the top cap of the water tank anti-
clockwise to unscrew it (fig. m).
7
Fill the water tank with cold tap water
(fig. n).
8
Turn the top cap clockwise to tightly lock it
onto the water tank (fig. o).
9
Place the water tank back into the
appliance (fig. p).