Get Started; Installing The Nano Protect Filter; Preparing For Humidification - Philips 5000 Series User Manual

3 Get started

Installing the Nano
protect filter
The appliance comes with the Nano
protect filter fitted inside. Remove the
packaging of the filter before using the
appliance. Remove the Nano protect
filter, unpack it, and place it back into
the appliance described as follows:
Note
• Make sure that the side with the tag
is pointing towards you.
• The pre-filter is fitted inside of the
back panel.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
Remove the Nano protect filter from
the appliance (fig. d).
3
Remove all packaging materials of
the Nano protect filter (fig. e).
4
Place the Nano protect filter back
into the appliance (fig. f).
5
To reattach the back panel, mount
the panel onto the bottom of the
appliance first, and then push
the top of the panel against the
appliance (fig. g).
Preparing for
humidification
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. i).
3
Remove all packaging material
of the NanoCloud rotary
humidification wick (fig. j).
Note
• The humidification wick has been
assembled on the wick wheel upon
purchase.
4
Place the wick wheel on the wick
support (fig. k).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
5
Place the water tray back into the
appliance (fig. l).
6
Turn the top cap of the water
tank anti-clockwise to unscrew it
(fig. m).
7
Fill the water tank with cold tap
water (fig. n).
8
Turn the top cap clockwise to tightly
lock it onto the water tank (fig. o).
9
Place the water tank back into the
appliance (fig. p).
EN
21