Wooden Wine Rack Trim Finishing; Operation; General; Interior Light - Perlick 24" C-Series Installation & Operation Manual

WOODEN WINE RACK TRIM FINISHING

All wine racks come with an unfinished solid hardwood face, which can
be removed and replaced with other wood to match the surrounding cab-
inetry.
The included unfinished faces can be finished and sealed. In many cases,
stains and/or finishes have odors that may be objectionable in an
enclosed area. To remove the front wood face from the wine shelf, simply
pull out the wine shelf and remove the fasteners. Finish as desired and re-
install with original fasteners.

OPERATION

General

The unit is equipped with a state-of-the-art refrigeration system and is a
frost-free model. The evaporator coil automatically defrosts on demand at
predetermined intervals.

Interior Light

The unit is equipped with an interior light that illuminates when the door
is opened. A manual switch is located next to light for displaying the
product through a glass door. Always ensure the manual switch is in the
off position before closing a solid wood or stainless steel door. If manual
switch is left on for an extended period of time, it may increase the cabi-
net temperature, especially at the top, and cause the refrigeration system
to run longer.
8
8 17 "
/
32
Ø 1 " x 5 "deep
/ /
8 16
8"
5
"
/
8
17 "
/
32
5
"
/
16
1
1 "
/
2
5
18
/
16
Figure 9. Wooden Wine Rack Trim
24" C-Series Operation / Installation Manual

Loading Product

I I M M P P O O R R T T A A N N T T : : Before storing perishables, allow unit to run for a minimum
of 24 hours to allow temperature stabilization after start-up.
When loading items into unit, do not block internal louvers and fan guard
openings or performance will be decreased.

Temperature Control

The controller is located at the top rear panel of the cabinet (Figure 10).
Approximate temperature operating ranges are:
Refrigerator: 33°F minimum, 39° maximum
Wine Reserve: 40°F minimum, 65° maximum
Beverage Center: 36°F minimum, 48° maximum
A A T T
D D J J U U S S T T I I N N G G E E M M P P E E R R A A T T U U R R E E
• Colder Temperatures: Turn the adjusting screw clockwise (to the
right).
• Warmer Temperatures: Turn the adjusting screw counterclockwise (to
the left).
• Temperature Control "OFF": Turn the adjusting screw completely
counterclockwise to the "OFF" position until a click is heard.
The condenser fan and motor turns off and on with the compressor.
8 17 "
/
32
5 "
/
8
7 1 "
/
17
1 "
4 /
32
"
Break all outside edges
1
"
/
2
© 2008