Manual Reception - Kyocera ECOSYS MA2100cfx Operation Manual

Using Convenient Fax Functions > Using a Connected Telephone

Manual Reception

Reception is possible after confirming that the telephone line has connected to the sending party.
1
2
3
4
5
NOTE
FAX Automatic Reception has been preset for the receiving mode of this machine. To use
Manual Reception, you need to change the receiving mode to Manual Reception. To change
to manual mode, refer to the following:
RX Settings (page 8-8)
The telephone rings.
When there is an incoming call, the telephone connected to the machine makes a ringing tone.
Lift the handset.
Lift the handset of the telephone.
Check if the telephone line has connected to the fax of the sending
system.
If the destination is a fax machine, you will hear soft beep sounds. If a person answers, you
can talk to that person.
[FAX] key > [On Hook] key > [Manual RX]
Reception will start.
NOTE
When using a telephone set that can send tone signals, use the telephone to start the
reception of originals with the remote switch function.
Remote SW Dial (page 8-8)
Replace the handset.
When reception starts, return the handset to its original position.
5-34