Table of Contents
Advertisement
6.6
GPIO Output signal specification
I/O Connector Pin No.
Output signal
Output level
Maximum Current
Polarity
Timer0 Active
Delay
Duration
TimerTriggerSource
6.7
Interface specification
Interface
Transmission speed
Protocol
6.8
LED states
Camera state
No power
Link detection in progress
Connection Error
SuperSpeed connected, but no data being transferred
SuperSpeed connected, waiting for trigger
Data being transferred
Error during data transfer
Stand-by
Copyright © 2017 TOSHIBA TELI CORPORATION, All Rights Reserved.
TIMER0 ACTIVE, USER OUTPUT, EXPOSURE ACTIVE,
FRAME ACTIVE, FRAME TRANSFER, FRAME TRIGGER WAIT
High active / Low active (factory setting : Low active)
0 to 2000000μs (factory setting : 0μs)
0 to 2000000μs (factory setting : 0μs)
Line0Active, ExposureStart, FrameTrigger
USB 3.0 (Only SuperSpeed is supported)
Lamp indication
Off
Fast flash green (ON:20ms, OFF:60ms)
Flash alternate red / green
Flash green (ON: 200ms, OFF: 800ms)
Flash orange (ON: 200ms, OFF: 800ms)
Fast flash green (ON:60ms, OFF:20ms)
Solid Red (Time period: 500ms)
Super slow flash orange (ON:200ms, OFF: 2800ms)
23
2 Pin : Line1
5V CMOS
+/-32mA
5Gbps (Maximum)
USB3 Vision
http://www.toshiba-teli.co.jp/en/
D4271476B
Advertisement
Table of Contents
