Advertisement
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
DO NOT power spray
No metal pans
Numbered Pads
1
End of Cycle Beep
2
Speaker Volume
3
Key Beep
4
Keyboard Enable
Window
5
Add Time During
Heating
6
Reset Door Open
7
Maximum Heating Time
8
Manual Operation
9
Double Digit Operation
0
Clean Filter Message
Part No.12834405
Printed in U.S.A. 1/11
Complete Owner's Manual available online
Can I change an option?
Options such as single or double pad programming, beep volume,
and maximum cooking time can be changed to suit individual
preferences.
To change options:
1. Open oven door.
• If door is closed or STOP/RESET
complete, changes are discarded and microwave exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET
pressed.
Display
Options (Factory Settings in Bold)
OP:10
3 second continuous beep.
OP:11
Continuous beep until door is opened.
OP:12
5 beeps bursts until door is opened.
OP:20
Eliminates beep.
OP:21
Sets volume to low.
OP:22
Sets volume to medium.
OP:23
Sets volume to high.
OP:30
Prevents beep when pad is pressed.
OP:31
Allows beep when pad is pressed.
OP:40
15 seconds after oven door is opened, keyboard disabled.
OP:41
30 seconds after oven door is opened, keyboard disabled.
OP:42
1 minute after oven door is opened, keyboard disabled.
OP:43
2 minutes after oven door is opened, keyboard disabled.
OP:50
Prevents adding heating time while oven is heating.
OP:51
Allows heating time to be changed while oven is heating when a memory pad
is pressed.
OP:60
Allows oven to resume heating time countdown after door is opened during
cycle.
OP:61
Cancels heating time count down after door is opened during cycle.
OP:70
Allows 60 minutes of heating time.
OP:71
Allows 10 minutes of heating time.
OP:80
Allows use of preprogrammed pads only.
OP:81
Allows use of manual time entry and preprogrammed pads.
OP:90
Allows 10 (0-9) preprogrammed pads.
OP:91
Allows 100 (00-99) preprogrammed pads.
OP:00
Do not display message.
OP:01
Display message for 24 hours every 7 days.
OP:02
Display message for 24 hours every 30 days.
OP:03
Display message for 24 hours every 90 days.
F
or full product documentation visit:
OPTIONS:
pad to save changes.
www.acpsolutions.com
pad is pressed before programming is
displays.
pad is
2011 ACP, Inc.
Cedar Rapids, Iowa 52404
Advertisement
