Advertisement
Quick Links
Commercial Microwave
120 V, 60 Hz Models
HDC12A2
P2002201M
P2001401M
P2001501M
P2003101M
P2003601M
P2003801M
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
Refer to Service Manual for installation, operating, testing, troubleshooting, and disassembly instruction.
All safety information must be followed as provided in Service Manual.
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitor
before servicing, unless testing requires it.
Power Source
Voltage AC
Amperage (Single Unit)
Frequency
Single Phase, 3 wire grounded
Receptacle
Plug
Power Output
Nominal microwave energy (IEC705)
Minimum temperature rise (∆T)
Operating Frequency
Power Consumption
Cook Condition Microwave
Dimensions
Cabinet
Width
Height
Depth
Oven Interior
Width
Height
Depth
Weight
Crated
Uncrated
July 2012
©2012 ACP, Inc.
Technical Information
—
!
CAUTION
!
W ARNING
Models
1
MDC12A2
P2002202M
P2001402M
P2001502M
P2003102M
P2003602M
P2003802M
HDC12A2
MDC12A2
120 VAC
20 A
60 Hz
X
5-20R
5-20P
1200 Watts
12ºF / 6.5ºC
2450 MHz
1900 Watts
16 3/4"
(42.5 cm)
13 1/2"
(34.3 cm)
22"
(55.9 cm)
13"
(17.1 cm)
6 3/4"
(3.3 cm)
12"
(30.5 cm)
73 lbs.
(33 kg)
67 lbs.
(30 kg)
16500038
Advertisement
Related Manuals for ACP HDC12A2
Summary of Contents for ACP HDC12A2
- Page 1 13 1/2" (34.3 cm) Depth 22" (55.9 cm) Oven Interior Width 13" (17.1 cm) Height 6 3/4" (3.3 cm) Depth 12" (30.5 cm) Weight Crated 73 lbs. (33 kg) Uncrated 67 lbs. (30 kg) July 2012 16500038 ©2012 ACP, Inc.
-
Page 2: Component Testing Procedures
Remove all wires from motor. Measure resistance across coil ....... Approximately 30 Ω. Antenna motor Remove all wires from motor. Measure resistance across terminals....Approximately 3.4 KΩ. Wire Harness Test continuity of wires ........Continuity. 16500038 July 2012 ©2012 ACP, Inc. - Page 3 6 & 9 Continuity 5 & 9 Continuity Start 4 & 9 Continuity Stop/Reset 4 & 8 Continuity Power Level 5 & 8 Continuity 6 & 8 Continuity Time Entry 7 & 8 Continuity July 2012 16500038 ©2012 ACP, Inc.
-
Page 4: Error Code Table
2. Press and hold pad 3 for five (5) seconds. NOTE: After five (5) seconds, SErv illuminates in the display. 3. Press pad 1 for Magnetron Hours. 4. Press pad 2 for Magnetron Cycles. 5. Press pad 3 for Door Cycles. 16500038 July 2012 ©2012 ACP, Inc. -
Page 5: Important Notes
13 .... 2400 17....1700 25 ....2500 9.5 ..... 1700 13.5 ..2500 18....1800 27 ....2700 10 ....1800 15 .... 2700 19....1900 30 ....3000 10.5 ... 1900 16.5 ..3000 July 2012 16500038 ©2012 ACP, Inc. -
Page 6: Wiring And Schematic Diagrams
Wiring and Schematic Diagrams To avoid risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitor before servicing, unless testing requires it. 120043101 DANG ER HIGH VOLTAGE 16500038 July 2012 ©2012 ACP, Inc. - Page 7 Wiring and Schematic Diagrams To avoid risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitor before servicing, unless testing requires it. 20043101 DANG ER HIGH VOLTAGE July 2012 16500038 ©2012 ACP, Inc.