Getting Started - CAME BX708ALS Installation Manual

PROGRAMMING
Programming button functions
1

Getting started

Once the electrical connections have been made, proceed with commissioning. Only skilled and qualified staff may perform this operation.
Make sure that there are no obstacles in the way.
Power up the device and begin programming.
Start programming with the functions indicated below.
F54
F1
A3
After powering up the system, the first manoeuvre is always to open the gate; Wait for the manoeuvre to be completed.
Press the STOP button immediately in the event of any faults, malfunctions, strange noises or vibrations, or unexpected behaviour in the system.
If the three display segments are flashing, calibrate the travel.
Total stop
Stop the gate and exclude automatic closing. Use a control device to resume movement.
F1
CX input
Associate a function with the CX input.
F2
The ESC button is used to perform the operations described below.
Exit the menu
Delete the changes
Go back to the previous screen
Stop the operator
The <> buttons are used to perform the operations described below.
Navigate the menu
Increase or decrease values
Open or close the operator
2 3
The ENTER button is used to perform the operations described below.
Access menus
Confirm a choice
Opening direction
Total stop
Travel calibration
Total stop
CX input
1 ESC button
2 < > buttons
ENTER button
3
Set the gate opening direction.
Stop the gate and exclude automatic closing. Use a control device to resume
movement.
Start the travel self-learning.
OFF (Default)
ON
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C7 = Reopening during closure (sensitive edges)
C8 = Reclose while opening (sensitive edges)
R7 = Reopen while closing (sensitive edges with 8K2 resistor)
R8 = Reclose while opening (sensitive edges with 8K2 resistor)