Advertisement
from the CAT5 wire and separate the colored conductors from
one another. Strip ½ inch of insulation from each conductor as
shown:
Connect each colored conductor to its respective screw
terminal. The screw terminals are marked with the appropriate
wire colors. Note: Some screw terminals have more than one
wire connected to them.
Mount each remote station to its mounting ring using the two
screws provided with each NM200 remote station
Nps200WH outdoor remote station
At each outdoor remote station location, strip approximately 4
inches of jacket from the CAT5 wire and separate the colored
conductors. Strip ½ inch of insulation from each conductor and
connect each colored conductor together using wiring wire
nuts.
Note: Some wires are doubled up when connected to the remote
station. Mount the outdoor remote station to the housing using
the 2 screws provided with the remote station.
iNstAlliNg tHe NA300mc volume coNtrol
At each NA300MC location strip approximately 4 inches of
jacket from wires and separate colored conductors from each
other. Wire nut each colored conductor to its respective wire as
shown in the next figure.
models Nm
Connect 18 gauge speaker cable wires to the corresponding
terminals of the satellite speakers. Mount the NA300MC to the single
gang box using the two screws provided with the volume control.
coNNectiNg tHe iA30WH Audio WAll plAte
Use the labels provided to mark respective cables. Connect
the cables to the IA30WH audio wall plate and mount the plate
using the two screws provided. Please see figure below and
refer to the NuTone IA30WH installation guide for more detailed
instructions.
iNstAlliNg tHe door stAtioNs
At each door station location, strip approximately 4 inches of
jacket from wire and separate colored conductors from one
another. Strip ½ inch of insulation from conductors. Cut each
shield drain wire at jacket to prevent them from touching each
other. Terminate yellow and orange wires to the screw terminals
on the chime pushbutton (if equipped). Connect the red and black
wires to the red and black wires on the speaker respectively.
Refer to figure below. Mount door station to housing using the
two screws provided with the door station.
200
200
WH • Nm
Al
Page
Advertisement
