Installing The Power-Adapter Port; System Board; Removing The System Board - Dell P105F Service Manual

3. Disconnect the power-adapter port-cable from the system board.
4. Lift the power-adapter port, along with its cable, off the palm-rest and keyboard assembly.

Installing the power-adapter port

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation
procedure.
Steps
1. Place the power-adapter port into the slot and adhere the power-adapter port cable on the system board.
2. Connect the power-adapter port cable to the system board.
3. Align and place the power-adapter port bracket over the power-adapter port.
4. Replace the two screws (M2x4) to secure the power-adapter port bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the rear cover
2. Install the base cover.
3. Follow the procedure in

System board

Removing the system board

Prerequisites
1. Follow the procedure in
38 Removing and installing components
After working inside your
Before working inside your
computer.
computer.