Power-Adapter Port; Removing The Power-Adapter Port - Dell P105F Service Manual

3. Replace eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
4. Turn the display assembly over.
5. Connect the display cable to the connector on the system board and close the latch to secure the cable.
6. Adhere the tape that secures the display cable to the system board.
7. Route the antenna cables through the routing guides on the fan and adhere the tape that secures the antenna cables to the
system board .
Next steps
1. Install the wireless card.
2. Install the rear cover
3. Install the base cover.
4. Follow the procedure in

Power-adapter port

Removing the power-adapter port

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the rear cover.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Remove the two screw (M2x4) on the power-adapter port-bracket that secures the power-adapter port to the palm-rest
and keyboard assembly.
2. Remove the power-adapter port-bracket from the power-adapter port.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 37