USB board
Removing the USB board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state drive
6. Remove the
solid-state drive
7. Remove the
wireless
card.
8. Remove the
memory
module.
9. Follow the procedure from step 1 to step 16 in
NOTE:
System board can be removed with the heat sink and USB board attached.
About this task
The following image indicates the location of the USB board and provides a visual representation of the removal procedure.
Steps
1. Turn the system board over.
2. Remove the two screws (M2x4) that secure the USB board to the system board.
3. Remove the USB board from the system board.
Installing the USB board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
1.
2.
Removing the system
computer.
board.
Removing and installing components
47