Advertisement
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet bo x.
13
Remove any shipping stabilizers if
present. Attach blade assembly to
motor using the motor screws and
washers provided. Tighten screws
securely.
© 2011 Monte Carlo Fan Company
11
House
Black
White
Green
For pullchain controls, follow diagr am above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house ma y
vary in color and ma y not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upw ard.
Refer to point 3 of safet y tips.
14
Remove 3 screws from the switch
housing plate and save to re-install
into the switch housing.
4
Fan
12
Black
Blue
White
Green(downrod)
Green(Bracket)
Loosen one and remove one pre-
assembled screw from mounting
bracket. Save screw. Lift canopy up,
aligning its keyhole slot with the pre-
assembled screw on mounting
bracket and twist clockwise to lock in
place. Re-install the removed screw
and tighten all screws securely.
15
Install the switch housing using the
3 screws previously removed.
Setting the reverse switch in the
left hand side will result in
downward airflow and setting the
switch in the right hand side will
result in upward airflow.
Reverse switch
2/11/2012
Advertisement
