Advertisement
1
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
4
Remove keeper from pin . (see
inset) Loosen the 2 set screws in
yoke for downrod to slip into
yoke.
7
Tighten both yoke set screws to fur -
ther secure downrod.
© 2011 Monte Carlo Fan Company
2
Before installing this fan mak e sure the outlet
box is properly installed to the house structure.
To reduce the risk of fire, electric shock, or per -
sonal injury, mount to outlet bo x or supporting
system acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
Thread wires and safety cable
through downrod with canop y and
yoke cover assembled.
8
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on the
ball engages the ridge in the mounting br acket.
This will allow hands-free wiring.
3
3
Install the Mountiing Br acket to the
Outlet box. Use only the screws
provided with the outlet box.
6
Insert downrod into motor y oke.
Next, insert clevis pin through y oke
and downrod and secure with cotter
pin.
9
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3" lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note:If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet Box.
2/11/2012
Advertisement
