Table of Contents
Advertisement
Output Commands
Command
FUNC?
OPER
OPER?
OUT
OUT?
RANGE?
RANGELCK
RANGELCK?
STBY
Measurement Commands
Command
PRES?
PRES_MEAS
RTD_MEAS
TC_MEAS
VAL?
ZERO_MEAS
ZERO_MEAS?
RS-232 Port Commands
Command
LOCAL
LOCKOUT
REMOTE
Returns the present output, measurement, or calibration function.
Activates the Calibrator output if it is in standby.
Returns the operate/standby setting.
Sets the output of the Calibrator.
Returns the output amplitude of the Calibrator.
Returns the present output range. (Voltage only).
Locks the present output range (Voltage only).
Returns the RANGELOCK state (Voltage only).
Deactivates the Calibrator output if it is in Operate mode.
Queries the attached pressure module for its model and serial number.
Changes the operating mode to pressure measurement.
Changes the operating mode to RTD measurement.
Changes the operating mode to thermocouple measurement.
Returns the last resistance, temperature, or pressure measurement value.
Zeros the pressure module.
Returns the zero offset for the pressure module.
Puts the Calibrator into the local state and disables lockout.
Puts the Calibrator into the lockout state. This command duplicates the
IEEE-488 LLO (Local Lockout) message.
Puts the Calibrator into the remote state. This command duplicates the
IEEE-488 REN (Remote Enable) message.
Remote Commands
Command Summary by Function
Description
Description
Description
5
5-3
Advertisement
Table of Contents
