Advertisement
Specifications
Specifications
Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc. states in its NFPA 96 latest edition that local codes are the "authority having jurisdiction" when
it comes to installation requirements for equipment. Therefore, installations should comply with all local codes.
Southbend reserves the right to change specifications and product design without notice. Such revisions do not
entitle the buyer to corresponding changes, additions, or replacements for previously purchased equipment.
This product is intended for commercial use only, not for household use.
The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149.1, or the Propane Installation Code
CAN/CGA-B149.2, as applicable, including:
1. The appliance and its individual shutoff valve must be disconnected from the gas supply piping system
during any pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).
2. The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less than
1/2 psi (3.45 kPa).
Electricity Supply
Convection ovens require connection to a supply of electricity. The appliance, when installed, must be electrically
grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable. An electrical diagram is located on the
side of the control panel assembly (see drawing on page 33). Electrical diagrams can also be found in this manual
beginning on page 34.
Power Option
120/60/1
208/60/1or3
240/60/1or3
240/50/1or3
Ovens ordered with the 120V power option are equipped with one, two, or three power cords with a standard 120V
single-phase plug with a ground prong. Single-deck ovens will have one power cord, double-deck ovens will have
two, and triple-deck ovens will have three.
Ovens with other power options have a terminal block on the rear of the oven that must be wired to the power
supply.
4
PAGE
OF 36
INSTALLATION & OPERATION MANUAL 1194658-ENGLISH, GAS, REV 1 (11/21)
Power Type
120 Volts, 60 Hz, Single Phase
190-219 Volts, 60 Hz, Single Phase
220-240 Volts, 60 Hz, Single Phase
208-240 Volts, 50 Hz, Single Phase
TruVection Gas Convection Ovens
NOTICE
Number of Ovens
Single-Deck
Double-Deck
Triple-Deck
Single-Deck
Double-Deck
Triple-Deck
Single-Deck
Double-Deck
Triple-Deck
Single-Deck
Double-Deck
Triple-Deck
Maximum Amps
7.9
15.8
23.7
4.3
8.6
12.9
3.8
7.5
11.4
6.0
12.0
18.0
Advertisement
