Test Mode; How To Use The Test Mode - JUKI LBH-1702 Manual

8. TEST MODE

(1) How to use the test mode

Input check of the various sensors can be performed.
1) Pressing [Right
2) Select the sensor No. you desire to make sure with [Left
No. 1 : Feed origin sensor, stitch base line sensor, stitch width origin sensor, and not used
No. 2 : Thread breakage detection, needle-up position detection sensor, knife return sensor, and presser fall
sensor
No. 3 : Not used, safety switch, start switch and presser switch
If you turn the sensor ON - OFF, the value will change 1/0.
Display when the sensor is ON :
1
(Feed origin sensor, stitch base line sensor, stitch width sensor and not used)
2
(Thread breakage detection, needle-up position detection sensor, knife return sensor, and presser fall sensor)
3
(Not used, safety switch, start switch, and presser switch)
] key 1, turn ON the power.
READY
2
0 1 1 –
0 0 1 0
– 1 0 0
RESET CLAMP WINDER
1
] or [Left
73
− −
THREAD
] key 2. (No. 1 to 3)