Table of Contents
Advertisement
1. Air pressure regulating knob
This regulates the air pressure as displayed in gauge on front of machine.
To adjust pressure pull knob upwards and turn to adjust pressure, once correct pressure is
obtained press down knob to secure - - Set air pressure to 50psi when test gas switch is
pressed
2. On/Off Switch
Turns machine on and off, the switch illuminates when machine turned on
3. Mains input cable
Fit required plug as per your electrical installation
4. Air inlet connector
Connect output hose from air regulator to this air input into machine ensuring hose clip is
secured tightly.
nd
5. 2
Earth connection
This can be used to earth the machine to workbench if you are experiencing interference from
8
Connections for Plasma 30DV
Rear Machine connections
Fig 1
Advertisement
Table of Contents
