Table of Contents
Advertisement
Display assembly
Description
12.1-inch, WXGA, BrightView, LED touch-screen display assembly (includes Web camera and cable,
microphones and cables, fingerprint reader and cable, WLAN antenna cables, and WWAN antenna
cables)
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power cord.
4.
Remove the battery (see
5.
Disconnect the WLAN antenna cables from the WLAN module (see
6.
Remove the hard drive (see
7.
Remove the top cover (see
Remove the display assembly:
1.
Close the computer and turn it upside down, with the rear panel toward you.
2.
Remove the two Phillips PM2.0×4.0 screws that secure the display hinge cover to the computer.
3.
Turn the computer display-side up, with the rear panel toward you.
4.
Open the computer display to the upright position and rotate the display (1) 90-degrees
clockwise.
56
Chapter 4 Removal and replacement procedures
Battery on page
36).
Hard drive on page
Top cover on page
49).
WLAN module on page
38).
Spare part number
611492-001
44).
Advertisement
Table of Contents
