Table of Contents
Advertisement
IMPORTANT: Check the filter regularly for optimal performance. An old or blocked filter will reduce
suction performance.
IMPORTANT! The vacuum cleaner is equipped with a float valve ( ② ) which is operational during
wet suction (Fig. 11). The suction power decreases when the maximum filling level is reached.
When this happens, switch the vacuum cleaner off immediately, and empty the container.
3. Blower Operation
WARNING!
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING!
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1) Make sure the container and any collected waste is emptied and the filter is dry before using as
a blower.
2) Insert the locking end of the hose into the blower port on the rear side of the power head (Fig. 12).
3) Turn on the motor on by turning the switch to the 'I' ON position.
CLEANING ARTIFICIAL LAWNS AND
1. Everyday Cleaning with Dry Suction
1) Clear large objects and debris from the lawn surface to ensure no large objects block or
damage the vacuum cleaner (Fig. 13).
2) Fit the artificial grass tool attachment to the floor head holder and attach this to the end of the
extension wands and hose (Fig. 14).
NOTE: The artificial grass tool has been specially developed for cleaning long fibers of artificial lawns.
3) Turn the motor on by assigning the switch to the 'I' ON position.
2. Remove Stubborn Dirt with Wet Suction
Stubborn dirt or mud that has been compacted into the surface is easier to remove and clean if the
lawn is wet.
1) Use a hose or watering can directly onto the stubborn dirt allowing the dirt to loosen and absorb
the water (Fig. 15).
2) Using the artificial grass tool, vacuum up areas to remove the dirt deep in the lawn fibers.
3. Brass Round Brush for Moss and Plant Removal
Nature likes to grow back into artificial lawns, moss especially likes the damp protected surface
of artificial grass. The brass brush will remove the moss from the lawn, without the use of
chemicals, the brass fibers are soft and gentle to surfaces compared to steel brushes.
WARNING:
ALWAYS TEST THE EFFECT OF THE BRASS BRUSH IN A SMALL
AREA. CHECK THAT THE BRUSH DOES NOT DAMAGE YOUR TYPE OF ARTIFICIAL
LAWN OR YOUR TYPE OF STONE WORK BEFORE CLEANING LARGE AREAS.
OUTDOOR AREAS
9
GB
Advertisement
Table of Contents
