Table of Contents
Advertisement
GB
Hard Floor Nozzle:
Attachment is suitable for wet or dry suction on hard floor surfaces. Ensure the squeegee is
located towards the back of the floor head holder and brushes towards the front.
Artificial Grass Tool:
Attachment is specifically designed for use on artificial lawns. Ensure the front lip is facing away
from the user and in the direction of vacuuming.
1. Switching On/Off
Connect the mains plug to a suitable a power outlet.
Position
I
O
2. Wet & Dry Vacuum Operation
WARNING:
'SAFETY INFORMATION'.
1) Verify that the washable filter and pre-filter are installed and the container latches are secured.
2) Secure the locking end of the hose into the vacuum suction port.
3) Push the desired accessories onto the hose nozzle. The air flow regulation allows you to
change vacuum cleaner suction. For best cleaning results, fully close the air flow regulation
(Fig. 7).
4) Plug the power cord into a power outlet.
5) Turn on the motor by assigning the switch to the "I" ON position.
6) Once you have completed vacuuming, switch to the "O" OFF position and unplug the power
cord from the power.
NOTE: If vacuuming a mixture of wet and dry surfaces, fully clean and dry the filter and collection
tank after each use.
Installing Cartridge filter:
WARNING:
CLEANER FILTER, ENSURE THAT THE POWER CORD IS UNPLUGGED AND
SWITCHED OFF.
1) To prepare your vacuum cleaner for wet or dry vacuuming, install the cartridge filter over the
filter cage ( ① ) with the flat end of the filter towards the vacuum power head. Carefully push
filter until it sits flush forming a tight seal (Fig. 8).
2) Place the filter retainer cap on top of cartridge filter over the raised lip and tighten the retainer
lock clockwise to secure against the internal filter cage (Fig. 9).
3) Place the nylon pre-filter over the cartridge filter, making sure the whole filter is covered and
secure the drawstring. Replace the power head, and secure it in place (Fig. 10).
OPERATION
Status
on
off
ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED
BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
8
Advertisement
Table of Contents
