Table of Contents
Advertisement
UNPACKING AND CHECKING CARTON
1 Power Head
2 Hose Storage
3 Latch
4 Accessory Storage
5 Caster
6 Container
7 Suction Port
8 On/Off Switch
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head. Secure them with
supplied screws (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for both wet and dry vacuum cleaning with the washable
cartridge filter and pre-filter pre-installed. If the cartridge filter is not installed, refer to page 8 & 9.
5) Secure the power head back on the container, using the latches. Insert the locking the end of
the hose into the suction port of the container and lock into place (Fig. 3).
6) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle
(Fig. 4).
Floor Nozzle Attachments
1) To remove the floor nozzle attachment, release the push clips on either side of the floor head
holder. The attachment should drop out from underneath (Fig. 5). Only one floor nozzle should
be attached at any given time.
2) To insert a new floor nozzle attachment, place one side of the attachment into the bottom of the
floor head holder and secure one clip in place. Push the other side up into place and ensure it
is securely fitted into the holder (Fig. 6).
CONTENTS
9 Carry Handle
10 Blower Port
11 Power Cord Storage Hook
12 Floor Head Holder
13 Extension Wand (x3)
14 Suction Hose
15 Crevice Tool
Washable Wet/Dry Filter
16
(pre-installed)
ASSEMBLY
7
17 Nylon Pre-filter (pre-installed)
18 Artificial Grass Tool
19 Hard Floor Tool
20 Brass Moss Removal Brush
21 Round Brush
22 Filter Retainer (pre-installed)
23 Screw (x6)
24 Instruction Manual
GB
Advertisement
Table of Contents
