Page 2
These instructions should be used to aid installation of the following products: T8BLED15EM1 / T8BLED16EM1 / T8BLED25EM1 / T8BLED26EM1 SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
Page 3
Single luminaire: squeeze the sides of the fitting together to separate the LED plate from the housing • Single luminaire: squeeze the sides of the fitting together to separate the LED plate from the housing • Twin luminaire: remove the two screws (see Fig. 1) and slide the LED plate away from the housing •...
Page 4
GENERAL This product contains a light source of energy efficiency class TBC to Regulat This product contains a light source of energy efficiency class D (T8BLED15EM1, T8BLED25EM1, T8BLED26EM1) / E ( T8BLED16EM1) to Regulation (EU) No. 2019/2015 This product contains a non-replaceable LED light source and a control gear w This product contains a non-replaceable LED light source and a control gear which can be replaced by a professional.
Page 5
If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not...
Page 6
TESTING FOR EMERGENCY LUMINAIRES Recommended routine test procedure in accordance with BS5266 • Daily check – check LED charge indicator is illuminated • Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation of key switch or switching off circuit breaker.
Page 7
230V 50Hz, IP20, Class 1, Non-Dim, house...
Page 8
INTERNAT CONTACT D INTERNATIONAL CONTACT DETAILS ML Accessories Limited LU5 4LT www.mlaccessories.co.uk DCAUG21_V6...
Need help?
Do you have a question about the T8BLED15EM1 and is the answer not in the manual?
Questions and answers