BWT WS255 Fitting And Operating Instructions page 2

This water softener complies with all
relevant local and national safety
requirements. Improper use will
invalidate your manufacturers
warranty and could lead to injury
and material damage.
To help avoid the risk of accidents
and unnecessary damage to this
unit, please read these instructions
carefully before installation and use.
Please keep these instructions in a
safe place and ensure they are
passed on to any future user of the
unit.
Electrical safety
Only use the transformer /plug supplied.
Before use, ensure that the connection
data on the data plate (voltage and
frequency) match that of the mains
electricity supply. If in any doubt, consult
a qualified electrician.
Maintenance
The unit must be isolated from the
electricity supply during installation,
maintenance and repair work. Your water
softener will benefit from regular service -
please see welcome pack or call BWT on
01494 838 100 for details.
Cleaning
Please wipe clean with a damp cloth.
Do not use solvent based or abrasive
cleaning agents as they may cause
damage to the high gloss finish.
Correct application
This appliance is intended for
domestic use only, and any other use is
not supported by the manufacturer and
could be dangerous. BWT UK Limited
cannot be held liable for damage
resulting from the incorrect or improper
use of this water softener.
Operation
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a safe
way and understand the hazards
involved.
Safety with children
Children must not play with the appliance
and any contents therein at anytime.
Extended periods of non-use
If the property is to be left unattended for
any length of time e.g. holidays, the
water softener should be bypassed/
isolated from the mains water supply by
reversing the 3 valve positions as shown
in the installation diagram in this manual.
After prolonged periods of non-use,
ensure inlet and outlet valves are open
and bypass valve is closed, and start a
manual regeneration as described in Part
Two of this manual.
Protect from high & low temperatures
Important - do not install the water
softener where it, or its connections
(including the drain overflow lines), will
be subject to temperatures under 5ºC or
above 40ºC.
2 2