Page 1
Einbau- und Bedienungsanleitung Einbau- und Bedienungsanleitung Einbau- und Bedienungsanleitung Einbau- und Bedienungsanleitung Einbau- und Bedienungsanleitung D D D D D Installation and Operating Instructions Installation and Operating Instructions Installation and Operating Instructions Installation and Operating Instructions Installation and Operating Instructions GB Be w w w w w amat amat amat...
1 Safety advice 1 Safety advice 1 Safety advice 1 Safety advice us by purchasing a BWT appli- us by purchasing a BWT appli- us by purchasing a BWT appli- us by purchasing a BWT appli- us by purchasing a BWT appli- ance.
You are obligated to take batteries to a suitable recycling point or return them, free of charge, to BWT. Old batteries contain valuable resources that can be reused. Microbiological and sensory quality of the softened water...
2 Scope of Deliv 2 Scope of Deliver er er er ery y y y y 2 Scope of Deliv 2 Scope of Deliv 2 Scope of Deliv 1 1 1 1 1 GB GB GB GB Bewamat A water-softening unit, Bewamat A water-softening unit, Bewamat A water-softening unit, with: Bewamat A water-softening unit,...
4 Function 4 Function 4 Function 5 Installation conditions 5 Installation conditions 5 Installation conditions 4 Function 4 Function 5 Installation conditions 5 Installation conditions GB GB GB GB The unit operates according to the principle of General information General information General information General information General information...
Page 6
The necessary operating pressure must always If flushing water is fed into a pump, it must be be guaranteed. designed for a water quantity of at least 2m /h or GB GB GB GB 35 l/min. If the pump is used for other units A minimum operating pressure is required for the simultaneously, it must be sized larger by a factor unit to function (see technical data).
6 Installation 6 Installation 6 Installation 6 Installation 6 Installation GB GB GB GB Place and align the softening column with control valve behind the cabinet. Run the the brine hose from the inside though the bore to the outside and insert it as far as it will go (a depth of about 15 mm) in the connection angle.
Firmly attach the flushing water hose into the flush- ing-water connection (9 9 9 9 9 ). GB GB GB GB Route the flushing water hose at an incline to the sewage system connection (drain) and secure the end with the supplied fixing material to prevent it moving around when under pressure.
7 Star 7 Star 7 Start-up t-up t-up t-up 7 Star 7 Star t-up GB GB GB GB Operation of the Controller Operation of the Controller Operation of the Controller Operation of the Controller Operation of the Controller Confirms Confirms Confirms Moves cursor, Moves cursor,...
Page 10
Check that the unit has been properly installed. GB GB GB GB Preparing the brine Preparing the brine Preparing the brine Preparing the brine Preparing the brine 4 4 4 4 4 Remove cover (4 4 4 4 4 ). P P P P P our regener our regener our regener...
V V V V V using the AQUATEST hardness tester. Adjust with the blending valve V V V V V until the desired value (BWT recommendation 4 - 8°d) is reached. The German Drinking Water Ordinance stipu-...
Setting the supply of softened water Setting the supply of softened water Setting the supply of softened water Setting the supply of softened water Setting the supply of softened water GB GB GB GB The unit is preset: Inlet water hardness of 20°d Blended water hardness of 4°d The supply of softened water is set if The supply of softened water is set if...
Setting the time/day of the week Setting the time/day of the week Setting the time/day of the week Setting the time/day of the week Setting the time/day of the week GB GB GB GB 4 4 4 4 4 08:32 08:32 08:32 08:32...
Changing the time of regeneration Changing the time of regeneration Changing the time of regeneration Changing the time of regeneration Changing the time of regeneration GB GB GB GB e.g. 5 5 5 5 5 07:43 07:43 07:43 07:43 07:43 e.g.
Adding regenerative Adding regenerative Adding regenerative Adding regenerative Adding regenerative GB GB GB GB Refill the regenerative no later than when the sieve base becomes visible or when SALt SALt SALt SALt is indicated SALt on the display. All commonly available regenera- tion salts (salt tablets in accordance with DIN EN 973 type A, e.g.
Check for dirt in the regenerating agent supply on time are not covered by the 2-year legal war- ranty. cavity and clean and rinse with clear water if required. BWT assumes no liability in the event that the unit Cleaning Cleaning Cleaning Cleaning...
11 T T T T T roub roub roub roubleshooting leshooting leshooting leshooting roub leshooting GB GB GB GB F F F F F ault ault ault ault ault Cause Cause Cause Cause Cause Action Action Action Action Action SALt SALt SALt SALt...
12 T T T T T echnical Specifications echnical Specifications echnical Specifications echnical Specifications echnical Specifications GB GB GB GB Bewamat Bewamat Bewamat type type type 25 A 25 A 25 A 75 A 75 A 75 A Bewamat Bewamat type type 25 A...
Page 20
BWT Ceská Republika s.r.o. BWT Ceská Republika s.r.o. BWT Ceská Republika s.r.o. BWT Ceská Republika s.r.o. BWT Polska Sp. z o.o. BWT Polska Sp. z o.o. BWT Polska Sp. z o.o. BWT Polska Sp. z o.o. BWT Polska Sp. z o.o.