3. Remove the assembly 3 from the base enclosure.
Reverse this procedure to install the modem module cable.
Power connector cable
Description
Power connector cable
✎
The power connector cable is also available in the Cable Kit, spare part number 516328-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. TV tuner module (see
d. Switch cover and keyboard (see
e. Speaker assembly (see
f. Display assembly (see
g. Top cover (see
h. System board (see
i. USB board (see
Remove the power connector cable:
1. Remove the Phillips PM2.5×7.0 screw 1 that secures the power connector and bracket 2 to the base enclosure.
Maintenance and Service Guide
"Battery" on page
"Optical drive" on page
"Hard drive" on page
4-11)
"TV tuner module" on page
"Switch cover and keyboard" on page
"Speaker assembly" on page
"Display assembly" on page
"Top cover" on page
4-34)
"System board" on page
"USB board" on page
4-41)
4-6).
4-7)
4-18)
4-23)
4-25)
4-37)
Removal and replacement procedures
Spare part number
538085-001
4-19)
4–45