JL Audio Stealthbox SB-T-TUNDCMAX/13TW5v2 Installation Manual

I N S T A L L A T I O N G U I D E
for the
SB-T-TUNDCMAX/13TW5v2
SKU#94410
2007 - 2013 Toyota Tundra CrewMax
This manual applies to both single and dual Stealthbox® installations.
Thank you for choosing a JL Audio Stealthbox ® for your automotive sound system. With proper installation, your new vehicle-specific
enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox
employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. Also, keep in mind
that your warranty coverage extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you prefer to
perform your own installation, please read this installation guide completely
before beginning the process.
® installed by your authorized JL Audio dealer. The installation professionals
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox ® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
SB-T-TUNDCMAX/13TW5v2 INSTR_SKU# 011266
INSTALLATION
D I F F I C U L T Y : 3
OUT
OF
ESTIMATED TIME:
2-3 HOURS
S T E P 1
Remove anything stored behind the rear seats and fold both
seats forward. If the truck is equipped with the OEM
Subwoofer, it must be removed and the rear panel will
need to be cut or, replaced with the panel from Toyota for
a truck not equipped with a OEM subwoofer. Call Technical
support (954) 443-1100 for further details if needed.
Test Stealthbox® for proper operation.
Using a Phillips head screwdriver remove the woofer from
the enclosure. The grille does not need to be removed
from the woofer! The grilles were removed in later pictures
for this document but they do not need to be for this
installation.
S T E P 2
Along the outside of the plastic panel that covers the back
of the cab on the drivers side, locate the seam between
the back and, side panels. Line up the first (or only)
enclosure with this seam.
If installing two enclosures, verify that there is adequate
room between the first enclosure and the elevated part
of the rear panel on the passengers side (as seen in the
photo for step (1)) to fit the second enclosure.
S T E P 3
Using a 1/8" drill, use the hole in the enclosure centered
behind the woofer as a guide, to drill a hole through the
plastic (and only the plastic) that covers the back of the
cab.
*CAUTION*
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
transmission lines, electrical wiring, exhaust systems
or anything else that might cause a reduction in
your weekly pay. Always wear eye protection when
drilling.
Continued on Next Page
5