HP Pavilion DV7-1020 Maintenance And Service Manual page 82

2. Remove the wireless antenna cables (2) from the routing channels in the top cover.
CAUTION:
To prevent damage to the display assembly, support it before removing the screws.
3. Remove the three Phillips PM2.5×13.0 screws (1) and the three Phillips PM2.5×6.0 screws (2) that
secure the display assembly to the computer.
4. Remove the display assembly (3).
NOTE:
computer models equipped with AntiGlare display assemblies. See steps 25 through 40 for display
assembly internal component removal information for computer models equipped with BrightView
display assemblies.
NOTE:
replacement instructions for computer models equipped with BrightView display assemblies.
5. If it is necessary to replace the display enclosure or any of the display assembly internal
components, remove the two rubber screw covers (1) on the display bezel lower edge. The rubber
screw covers are available in the Display Rubber Kit, spare part number 495896-001.
74 Chapter 4 Removal and replacement procedures
The display assembly will be unsupported when the following screws are removed.
Steps 5 through 24 provide display assembly internal component removal information for
See Webcam/microphone module on page 53 for webcam/microphone module