NEC E438 User Manual page 4

FCC Information
CAUTIONN:


To assure continued compliance and prevent possible undesirable interference, ferrite cores may be used when connecting this LCD TV to
video equipment; and maintain at least 400mm spacing to other peripheral device.
Use the attached specified cables with the E658 / E558 / E498 / E438 / E328 of LCD TV so as not to interfere with radio and television
reception.
(1) Please use the supplied power cord.
(2) Please use the supplied shielded HDMI signal cable.
(3) For AV, please use a shielded signal cable.
(4) For mini D-Sub 15-pin and USB, please use a shielded signal cable with ferrite core.
(5) For D-sub 9-pin and Coaxial, please use a shielded signal cable.
(6) Connections to this device must be made with shielded cables with metallic RF / EMI connector hoods to maintain compliance with FCC
Rules and Regulations.

ARNINNN:


The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by NEC Display
Solutions of America, Inc. in this manual. Failure to comply with this government regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER'S DECLARATION OF CONFORMITY
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
U.S. Responsible PartyN:
AddressN:
Tel. No.N:
Type of Product:
Equipment Classification:
Model:
Canadian Notice
Cable-Compatible Analog and Digital Television Receiving Apparatus — Appareil de réception de télévision analogique et numérique
câblocompatible, Canada BETS-7 / NTMR-7.
NOTEN:
(1) The contents of this manual may not be reprinted in part or whole without permission.


(2) The contents of this manual are subject to change without notice.
(3) Great care has been taken in the preparation of this manual; however, should you notice any questionable points, errors or
omissions, please contact us.
(4) The image shown in this manual is indicative only. If there is inconsistency between the image and the actual product, the actual
product shall govern.
(5) Notwithstanding articles (3) and (4), NEC will not be responsible for any claims on loss of profit or other matters deemed to result
from using this device.
(6) This manual is commonly provided to all regions so they may contain descriptions that are pertinent for other countries.
NEC Display Solutions of America, Inc.
3250 Lacey Rd, Ste 500
Downers Nrove, IL 60515
(630) 467-3000
LCD TV
Class B Peripheral
E658 E558 E498 E438 E328
English - 1