Eneo ICB-62M2713MAA User Manual page 63

1/2.8” network camera, 1920x1080, day&night, dol wdr, 2.7-13.5mm, infrared, ip67

Hide thumbs Also See for ICB-62M2713MAA:

Table of Contents

MEGA-PIXEL NETWORK CAMERA

Full Menu Setup

RTP

●

> START PORT & END PORT : RTP port range defines the range of the ports from

which ports of the video/audio are automatically selected. This feature is useful if the

camera is connected to a NAT router with manually configured port mapping. Limit the

range of the ports permitted for RTP unicast/multicast by entering START PORT and

END PORT.

> MULTICAST - STREAM1, 2, 3 : Only IP addresses within certain ranges can be used

for multicasting. The camera has been pre-configured with addresses from these ranges

and does not normally need to be reconfigured. If an address needs to be changed,

please contact the network administrator.

• Mark ENABLE checkbox to use the multicast for each stream.

• DESTINATION IP: Type IP address in the range. Multicast addresses are allocated

according to these IANA policies.

• PORT : Use the port number in the range 1024-65532. Default is 4000.

• TTL : When IP packets or data fails to be delivered to the destination within TTL

(Time To Live), this setting tells the network router when to discard the packet. The

value is usually measured in 'hops', i.e. the number of network routers that can be

passed before the packet arrives at its destination or is dropped.

Table of Contents