MEGA-PIXEL NETWORK CAMERA
Full Menu Setup
To set the motion detection area (up to 4 include-types and 4 exclude-types) :
1) Mark ENABLE checkbox.
2) In the video window, place the mouse cursor where you would like to make a detection
window and click&drag the right button. The following window is then generated.
• INCLUDE-Type : defines areas where motion should be detected.
• EXCLUDE-Type : defines areas within a window that should be ignored.
3) Enter a name and then click SAVE.
[ NOTE ]
Motion detection and VCA cannot be used simultaneously. If either one is enabled,
the other one is disabled automatically.
Tamper
●
The camera can detect severe changes in the image caused by actions such as
repositioning the camera or painting over of the lens and generates an alarm to alert.
> Mark ENABLE checkbox to activate the tamper alarm.
> DWELL TIME : Sets the time for the tamper alarm once detected.
System
●
Used to trigger the event when the camera gets rebooted.
> Mark ENABLE checkbox to activate the system event.
> DWELL TIME : Sets the time for the alarm once the system event is detected.
46