Westermo Viper-TBN Series Manual page 21

a
100 Mbps ports
Electrical specification
Data rate
Duplex
Transmission range
Isolation
Connector
Cabling
Conductive chassis
FRNT reconfiguration time
Circuit type
a
100 Mbps ports are port X1-X8 on Viper-208-TBN and ports X5-X8 on Viper-208-T4G-TBN
b
In case of bypass, no isolation between X5 to X7 and X6 to X8
a
Gbps ports
Electrical specification
Data rate
Duplex
Transmission range
Isolation
Connector
Cabling
Conductive chassis
FRNT reconfiguration time
Circuit type
a
Gbps ports are: X1-X4 on Viper-208-T4G-TBN, X1-X8 on Viper-208-T8G-TBN. Viper-208-TBN has no Gbps
ports.
b
For 1 Gbps, auto negotiation is always enabled
c
In case of bypass, no isolation between X5 to X7 and X6 to X8
IEEE std 802.3
10 Mbps, 100 Mbps, manual or auto
Full or half, manual or auto
Up to 150 m with CAT5e cable or better
b
To all other ports
4-pin, female, M12 screw connection, D-coded, auto MDI/MDI-X,
recommended Westermo cables:
3146-1100 M12-M12 - 1 m
3146-1101 M12-M12 - 5 m
3146-1103 RJ45-M12 - 1 m
3146-1104 RJ45-M12 - 5 m
Shielded cable CAT5e or better is recommended
Yes
Typically below 20 ms
TNV-1
IEEE std 802.3
10 Mbps, 100 Mbps, 1 Gbps, manual or auto
Full or half, manual or auto
Up to 150 m with CAT5e cable or better
c
To all other ports
8-pin, female, M12 screw connection, X-coded
Shielded cable CAT5e or better is recommended
Yes
Typically below 20 ms
TNV-1
Viper-TBN Series
b
21