Table of Contents
Advertisement
of an intrusion for 30 seconds. Then it will stop and automatic reset and re-arm.
If the one of sensors or detectors still active, the alarm system will sound a
maximum of 3 times of 30 seconds cycles.
Door Trigger
Trunk/Hood Trigger
Ignition Trigger
NOISE ABATEMENT CIRCUIT: You system has "Noise Abatement Circuit". It
prevents annoying repetitive trigger sequences due to faulty door pin switches
or environmental condition such as thunder, jackhammers airport noise, etc.
Here's how "Noise Abatement Circuit" works: The alarm triggers 3 times. Each
time, the same sensor or switch is triggering the alarm. "Noise Abatement
Circuit" will interpret this pattern of triggers as false alarm. After the third trigger,
"Noise Abatement Circuit" ignores, or bypasses, that sensor or switch until the
other sensor or switch is trigger.
"Noise Abatement Circuit" covers doors (Hood/Trunk) differently: If the alarm is
triggered by an open door for three full cycles, the doors will be bypassed until
the trigger ceases.
O. ANTI CAR- JACKING
Warning: If you don't need the car jacking function in this alarm system, be
sure to set car jacking feature "OFF". This system is default setting all
car-jacking "OFF".
ACTIVE ANTI CAR JACKING:
1. Press and hold the transmitter
seconds while the vehicle's ignition is ON. The parking lights will turns on for
1.5 seconds to indicate this enter.
2. Once the system is armed, If you are forced from the vehicle, the system will
trigger when the door is opened and closed while the ignition is "ON".
PASSIVE ANTI CAR- JACKING:
It operate as below:
1. Turn the ignition switch to the "ON" position; the system will arm.
2. Once the system is armed, If you are forced from the vehicle, the system will
trigger when the door is opened and closed while the ignition is "ON".
TRIGGER THE ANTI CAR -JACKING MODE:
3-timer circuits will function as follows:
First timer:
Warn-away Trigger Shock Sensor Trigger
CLEAR THE FLASH ICON AND MELODY SOUND: While
triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press the
button 3 times within 3 seconds will clear the flash icon and
stop melody sound on the LCD screen transmitter.
STOP THE MELODY SOUND ONLY: While triggering the
alarm the LCD screen will alert user through melody sound
and flashing trigger icon, press any button on the LCD
remote transmitter to stop melody sound only
and
button at the same time for 2
18
Advertisement
Table of Contents
