To Install Video Support For Retail Windows Nt 4.0; To Install Audio And Modem Support For Retail Windows Nt - HP OmniBook XE2 Evaluator Manual

Using Windows NT 4.0
Installing Retail Windows NT 4.0

To install video support for retail Windows NT 4.0

If you've installed a retail version of Windows NT 4.0, you'll need to install
video support. The driver expands from the web package to its default location
in \OMNIBOOK\DRIVERS\VIDEO.
1. From Control Panel, double-click Display, then click Settings.
2. Click Display Type, then click Change.
3. Click Have Disk in the Change Display window.
4. Enter the directory of the video driver and click OK.
5. Select the Silicon Motion Lynx Family video driver, then click OK.
6. Click Yes to proceed.
7. Click OK to accept that the driver was successfully installed.
8. Click Close in the Display Type window. (The new driver will not take
effect until after Windows NT has restarted.)
9. Click Close in the Display Properties window.
10. Click Yes to restart the computer.
11. When Windows NT restarts, it displays a message that a new graphics
driver has been installed. When you see this message, click OK.
12. Select the appropriate resolution, click Test, then click OK.
1024 x 768 on the OmniBook XE2 with 14.1" display
800 x 600 on the OmniBook XE2 with 12.1" display
13. If the graphic is correctly displayed, click Yes, otherwise click No and
change the setting.
14. Click OK.
To install audio and modem support for retail
Windows NT 4.0
If you've installed a retail version of Windows NT 4.0, you'll need to install
audio and modem support. The driver expands from the web package to its
default location in \OMNIBOOK\DRIVERS\AUDIO.
1. From the Start menu, click Run.
2. Browse to \OMNIBOOK\DRIVERS\AUDIO\SETUP.EXE.
3. Click Next at the Welcome screen.
4. Click Next to install the drivers.
5. Click Finish to restart the computer.
7-6