Installing Cards; To Install A 3Com 3C589D Etherlink Iii Pc Card - HP OmniBook XE2 Evaluator Manual

Using Windows NT 4.0

Installing Cards

Installing Cards
This section describes how to install the following:

To install a 3Com 3C589D EtherLink III PC Card

Requirements
Resources
These procedures assume Phoenix Card Executive is installed and Windows
Note
NT Networking is not.
For more information on installing PC Cards in Windows NT, visit our web site:
www.hp.com/omnibook.
1. Insert the CD-ROM drive in the OmniBook and restart Windows NT 4.0.
2. Insert the PC Card.
3. When the PCMCIA Card Not Configured window appears, select Install
4. Insert the Windows NT Installation CD in the CD-ROM drive, enter the
5. Enter the resource assignments above and click OK.
6. Click OK to the setup message. (The card has not been activated yet.)
7. If you installed the TCP/IP protocol, you will be asked if you wish to use
8. If you chose not to use DHCP, you will be prompted to enter your TCP/IP
9. If you chose to use DHCP, there will be a slight pause while it attempts to
10. When prompted, restart Windows NT 4.0.
7-12
3Com 3C589D EtherLink III PC Card.
3Com 3C575 Fast EtherLink XL CardBus PC Card.
OmniBook XE2 with Windows NT 4.0 installed.
3Com 3C589D EtherLink III PC Card.
Windows NT 4.0 CD-ROM.
Interrupt: 11
I/O: 0x1000
Memory 0xD4000
system provided driver for this card and click OK.
\i386\ directory and click OK.
DHCP. Select the appropriate choice for your network.
information.
find the DHCP server, click Yes when prompted.