To Install Video Support For Retail Windows Nt 4.0 - HP OmniBook 4100 Reference Manual

To install video support for retail Windows NT 4.0

If you've installed a retail version of Windows NT 4.0, you'll need to install video
support. The driver is located on the Recovery CD in \Omnibook\Drivers\Nt40\Video.
1. Insert the Recovery CD into the CD-ROM drive.
2. From Control Panel, double-click Display, then click Settings.
3. Click Display Type, then click Change.
4. Click Have Disk in the Change Display window.
5. Type the CD-ROM drive letter followed by \Omnibook\Drivers\Nt40\Video, then
click OK.
For example: D:\Omnibook\Drivers\Nt40\Video.
6. Select the NeoMagic MagicGraph 128XD, then click OK.
7. Click Yes to proceed.
8. Click OK to accept the installed driver.
9. Click Close in the Display Type window. (The new driver will not take effect until
after Windows NT has restarted.)
10. Click Close in the Display Properties window.
11. Click Yes to restart the computer (If you need to install other components, do
not restart at this time).
12. When Windows NT restarts, it displays a message that a new graphics driver has
been installed. When you see this message, click OK.
13. Select the following resolution, click Test, click OK.
1024x768
14. If the graphic is correctly displayed, click Yes, otherwise click No and change
the setting.
15. Click OK.
Using the Recovery CD
Installing Retail Windows NT 4.0
1-103