Hard Disk Drive Problems - HP OmniBook 6100 Reference Manual

If the drive A icon is missing for the floppy drive when docked
• For Windows 98, if you insert the floppy drive after docking, the drive A icon may
not be available. To be recognized, the drive must be present when the computer
docks or boots. If the drive A icon is missing, either dock the computer again with the
floppy drive installed, or reboot the computer.
If an IDE drive in a docking system doesn't work
• If you install an IDE drive in a docking system PC device bay, you should set the IDE
jumpers on the drive to the Single or Cable Select setting. Whenever you want to
partition or format a drive that's larger than 8 GB, you must first use Device Manager
to turn on the Int 13 setting for the IDE drive.

Hard Disk Drive Problems

If the computer's hard drive doesn't spin
• Make sure the computer has power. If necessary, connect the AC adapter, and make
sure it is fully plugged into a power source and into the rear of the computer.
• Remove and reinsert the hard drive. See "Replacing the Hard Disk Drive" on page 96.
If the hard disk makes a buzzing or whining noise
• Back up the drive immediately.
• See whether the noise is coming from elsewhere, such as from the fan or a PC Card
drive.
If files are corrupted
• For Windows 98, run the Scandisk surface scan to check the hard disk. From the Start
menu, click Programs, Accessories, System Tools, Scandisk.
• For Windows 2000 or XP, open My Computer, select the disk you want to scan, click
File, Properties, and use the Tools tab.
• Run the virus-scanning program. See "To protect against viruses" on page 41.
• Test the hard disk drive with the e-Diagtools diagnostics. See "Testing the Hardware"
on page 123.
• If necessary, you can format the hard disk and reinstall the original factory software.
See "To recover the factory installation of your hard disk" on page 132.
Troubleshooting and Maintenance
Troubleshooting Your Computer
Reference Guide 105