Power/Battery Pass-Through Board - HP Mini 110-1020 Maintenance And Service Manual

Power/battery pass-through board

Description
Power/battery passthrough board
Before removing the power/battery pass-through board, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
Remove the power/battery pass-through board:
1. Disconnect the power cable (1).
2. Remove the 2 Phillips BP2.5×5.0 screws (2) that secure the power/battery passthrough board to
the base enclosure.
3. Remove the power/battery pass-through board (3).
Reverse this procedure to install the power/battery pass-through board.
56 Chapter 4 Removal and replacement procedures
Battery on page 36).
Keyboard on page 40)
Mass storage devices on page
Top cover on page 48)
Spare part number
537615-001
SIM on page 37.
45)