Using System Restore; Using Hp Mi Restore Image Creator; Restoring Using A Windows Computer - HP Mini 110-1020 Maintenance And Service Manual

Using System Restore

NOTE: System Restore is the recommended option to restore the original operating system.
To restore the original operating system and programs using the System Restore utility that is installed
on the device, follow these steps:
1. Turn on or restart the device, and then press the
Options" message is displayed in the lower-left corner of the screen.
The "System Restore" page opens.
2. Use the arrow keys to select System Restore, and then press enter.
3. Follow the on-screen instructions to restore the system.

Using HP Mi Restore Image Creator

NOTE: Use HP Mi Restore Image Creator if you are unable to boot (start up) the device, and if you
are unable to use System Restore.
You will need the following before you begin this restore process:
●
A 2-GB (minimum) USB flash drive (purchased separately)
NOTE:
manufacturer for additional information.
●
An additional computer running either a Windows® or Linux operating system
To perform this restore option, you download the HP Mi Restore Image Creator utility and Mini operating
system onto another computer and then transfer the necessary files to the USB flash drive. The drive
can then be used to reboot your device and restore the system.
Follow the specific operating system instructions in this section to restore your system.
CAUTION:
files you have created and any software installed on the device are permanently removed. The restore
process reinstalls the original operating system, software, and drivers. Software, drivers, and updates
not installed with the factory image must be reinstalled using Update Manager.

Restoring using a Windows computer

To download the files to a computer running a Windows operating system and then restore your device,
follow these steps:
1. From your Windows computer, go to http://www.hp.com.
2. Click the Support & Drivers tab.
3. Under "Step 1: Start by selecting a task," select Download drivers and software (and
firmware) .
4. Under "Step 2: Enter a product name / number," type the part number/product number (p/n) of your
Mini, and then click Go.
NOTE:
5. Under "Which operating system is used with your product?" click HP Mi or click Linux .
98 Chapter 8 Backup and recovery
This USB flash drive should have bootable capability. Refer to the USB flash drive
The restore process reformats and completely erases the hard drive on the Mini. All the
The p/n is located on the service tag affixed to the bottom of your Mini.
esc key repeatedly while the "F10 = BIOS Setup