Fan - HP Mini 110-1020 Maintenance And Service Manual

Fan

Description
Fan
NOTE: To properly ventilate the device, allow at least a 7.6-cm (3-inch) clearance on the left side of
the device. The device uses an electric fan for ventilation. The fan is controlled by a temperature sensor
and is designed to turn on automatically when high temperature conditions exist. These conditions are
affected by high external temperatures, system power consumption, power management/battery
conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced
through the ventilation grill located on the left side of the device.
Before removing the fan, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
Remove the fan:
1. Disconnect the fan cable (1).
2. Remove the 2 Phillips PM2.5×5.0 screws (2) that secure the fan to the base enclosure.
Battery on page 36).
Keyboard on page 40)
Mass storage devices on page
Top cover on page 48)
SIM on page 37.
45)
Component replacement procedures
Spare part number
537613-001
57