Power Connector Cable - HP G60-231 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Optical drive (see
c. Hard drive (see
d. Keyboard (see
e. Keyboard cover (see
f. Power button board (see
g. Display assembly (see
h. Top cover (see
i. Bluetooth module (see
j. System board (see
✎
The power cable connector was released from its mounting clip in the base assembly during system
board removal.
To remove the power connector cable, disconnect the cable connector from the system board.
Reverse this procedure to install the power connector cable.
Removal and replacement procedures
"Battery" on page
"Optical drive" on page
"Hard drive" on page 4-10)
"Keyboard" on page 4-17)
"Keyboard cover" on page
"Power button board" on page
"Display assembly" on page
"Top cover" on page 4-30)
"Bluetooth module" on page
"System board" on page
4-7).
4-8)
4-20)
4-22)
4-23)
4-35)
4-38)
Spare Part Number
496835-001
4–46