Compaq Evo N620c Series Software Manual page 80

Setup and Diagnostic Utilities
4. Select a test type:
❏
❏
❏
5. Select a test mode:
❏
❏
6. Select the Begin Testing button.
7. To view a test report after a test has run, select a tab:
❏
❏
❏
7–12
Quick Test runs a quick, general test on each device in a
selected category.
Complete Test performs maximum testing on each device
in a selected category.
Custom Test performs maximum testing on a
selected device.
◆
To run all tests for your selected device, select the
Check All button.
◆
To run only the tests you select, select the Uncheck
All button, then select the check box for each test you
want to run.
Interactive Mode provides maximum control over the
testing process. You determine whether the test has been
passed or failed. You may be prompted to insert or
remove devices.
Unattended Mode does not display prompts. If errors are
found, they are displayed when testing is complete.
The Status tab summarizes the tests that have been run,
passed, and failed during the current testing session.
The Log tab lists the tests that have been run on the
system, the number of times each test has run, the
number of errors found on each test, and the total run
time of each test.
The Error tab lists all errors found on the notebook with
their error codes.
Software Guide