Removing Other Components; Table 2-5. Removing Components - HP Compaq Evo N1010v Series Service Manual

Removing Other Components

(Service Partners Only)
Required Equipment
•
0 and 1 Phillips screwdrivers
•
Small flat-blade screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. Remove the assemblies, and then follow the additional steps listed in the table below.
Component
Battery, CMOS
Case, bottom
Case, top
CD/DVD drive
CPU module
Display assembly
Doors, PCMCIA
Floppy drive
Service Manual

Table 2-5. Removing Components

Removal Procedure
Keyboard cover(page 2-13)
Speaker (page 2-15)
Keyboard (page 2-16)
Switchboard PCA(page 2-19)
CD/DVD (page 2-20
Display (page 2-23)
Top case (page 2-26)
Floppy (page 2-32)
Heat sink (page 2-40)
Motherboard (page 2-50)
See page 2-3
See page 2-3
See page 2-3
See page 2-44
See page 2-23.
Keyboard cover(page 2-13)
Speaker (page 2-15)
Keyboard (page 2-16)
Switchboard PCA(page 2-19)
CD/DVD (page 2-20
Display (page 2-23)
Top case (page 2-26)
Heat sink (page 2-40)
Floppy (page 2-32)
Motherboard (page 2-50)
See page 2-32
Additional Steps
Reassembly Notes: After replacing the
CMOS battery, set the correct time and
date using the BIOS Setup utility or
Date/Time in the Control Panel.
See page 2-3
Removal and Replacement 2-61