Network Cable - HP EliteBook 8740W Maintenance And Service Manual

d. Display assembly (see
e. Top cover (see
Remove the USB board:
1. Remove the Phillips PM2.5×4.0 screw (1) that secures the USB board to the system board.
2. Lift the left side of the USB board (2) to disconnect it from the system board.
3. Lift the USB board (3) straight up and remove it.
4. Remove the USB board.
Reverse this procedure to install the USB board.

Network cable

NOTE: The network cable is included in the Cable Kit, spare part number 596040-001.
Before removing the network cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Optical drive (see
drive on page
b. Keyboard (see
c. Switch cover (see
94 Chapter 4 Removal and replacement procedures
Display assembly on page
Top cover on page 83)
Battery on page 46), and then remove the following components:
Optical drive on page
53)
Keyboard on page 61)
Switch cover on page
74)
52) or secondary hard drive (see
65)
Secondary hard
ENWW