System Board - HP EliteBook 8740W Maintenance And Service Manual

d. Display assembly (see
e. Top cover (see
Remove the network cable:
1. Disconnect the network cable (1) from the system board.
2. Release the network cable from the clips (2) built into the base enclosure.
3. Release the network cable ferrite (3) from the clip built into the base enclosure.
4. Release the RJ-45 jack (4) from the clip built into the base enclosure.
5. Remove the network cable.
Reverse this procedure to install the network cable.

System board

Description
For use in all countries and regions except the People's Republic of China and Russia:
●
For use with computer models equipped with Intel Quad Core processors
●
For use with computer models equipped with Intel Dual Core processors
For use only in the People's Republic of China and Russia:
●
For use with computer models equipped with Intel Quad Core processors
●
For use with computer models equipped with Intel Dual Core processors
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
ENWW
Display assembly on page
Top cover on page 83)
74)
Spare part number
595700-001
595698-001
598446-001
598445-001
Component replacement procedures 95