Rj-45 (Network) Cable - HP ZBook 15 G2 Mobile Workstation Maintenance And Service Manual

RJ-45 (network) cable

NOTE: The RJ-45 (network) cable is included in the Cable Kit, spare part number 785222-001.
Before removing the RJ-45 (network) cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Top cover (see
f. ExpressCard assembly (see
g. Audio/USB board (see
h. USB board (see
i. Speakers (see
j. Fan/heat sink assembly (see
k. Display assembly (see
Remove the RJ-45 (network) cable:
1. Remove the Phillips PM2.0×5.5 screw (1) that secures the left-side rear corner cover to the
base enclosure.
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 44), and then remove the following components:
Service cover on page
Hard drive on page 46)
Optical drive on page
Keyboard on page 57)
Top cover on page 65)
ExpressCard assembly on page
Audio/USB board on page
USB board on page 78)
Speakers on page 80)
Fan/heat sink assembly on page
Display assembly on page
45)
48)
74)
77)
81)
87)