Compaq Contura 400 Maintenance And Service Manual page 266

Been Detected
by POST
---------------------------------------------------------------------------
1125 - 2 Short
Internal
Serial Port
Failure
---------------------------------------------------------------------------
1780 - Disk 0 None
Failure
---------------------------------------------------------------------------
1782 - Disk None
Controller
---------------------------------------------------------------------------
1790- Disk 0 None
Failure
---------------------------------------------------------------------------
Audible 1 Short
---------------------------------------------------------------------------
Audible 2 Short
---------------------------------------------------------------------------
(RESUME = F1 None
KEY)
===========================================================================
Chapter 5.2 Computer Checkup (TEST) Error Codes
Computer Checkup (TEST) error codes occur if the system recognizes a
problem while running Computer Checkup. These error codes help identify
possible defective assemblies. Tables 5-2 through 5-12 list Computer
Checkup error codes, a description of the error condition, and the
recommended action for resolving the condition. For removal and
replacement procedures, refer to Chapter 3.
IMPORTANT: Rerun Computer Checkup each time you complete a recommended
action step. If the problem is resolved when POST and Computer
Checkup are rerun (i.e., with no error codes), do not perform
the remaining recommended action steps.
NOTE: The error codes in the following tables are listed in an AYY-XX
format, where:
A or AA = Number that represents the faulty assembly.
YY = Test or action that failed.
XX = Specific problem.
Table 5-2. Processor Computer Checkup Error Codes
===========================================================================
Error Code Description
===========================================================================
101 - xx CPU test failed
102 - xx Coprocessor error
Defective
internal serial
port
Hard drive/format
error
Hard drive
circuitry error
Hard drive error
or wrong drive
type
Power-on
successful
Power-on
successful
As indicated to
continue
Recommended Action
Replace the system board.
Replace the system board.
3. Replace the system board.
1. Run Computer Setup and
Check it.
2. Replace the system board.
1. Run Computer Checkup.
2. Replace the drive.
1. Run Computer Checkup.
2. Replace the drive.
1. Run Computer Setup and
Computer Checkup.
2. Change drive type.
3. Replace the drive.
None.
None.
Press the F1 key.