Compaq Contura 400 Maintenance And Service Manual page 168

10. Carefully insert the end of the display cable into the ZIF connector
slide on the system board.
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it.
cable is fully seated (to the white insertion line) in the
ZIF connector.
11. While holding the end of the display cable inside the ZIF connector
slide, press down both ends of the slide simultaneously to secure the
cable in the ZIF connector (Figure 3-116).
Before closing the slide, ensure that the